Sabrent EC-UEIS7 Manuale Utente

Sabrent EC-UEIS7 USB 2.0/ESATA TO 3.5″ IDE/SATA/SATA II ALUMINUM HARD DRIVE ENCLOSURE WITH COOLING FAN 1. Device Setup 3.5 Inch IDE Drive: 1. Che

3. Remove the IDE power cable from the enclosure. Attach the SATA power cable in the same plug: Figure A: Figure B:

Figure C: Figure D:

4. Locate the SATA power cable. Connect it to the SATA power port on your drive: Figure A: Figure B:

Figure C: 5. Insert the hard drive into the enclosure, as shown below: Figure A: Figure B:

6. Place the cover back on the enclosure. Screw it back in place: Figure A: 2. Computer Setup 1. Connect the USB cable into the USB port on the e

Alternatively, connect the E-Sata cable into the E-Sata port if you require it. (Note: E-Sata connector may be a bit difficult to plug in, and may req

Figure B: 3. Plug the USB or E-Sata cable into your computer’s USB or E-Sata port: 4. Flip the power switch ON: Driver Setup Windows 2000/XP/Vi

1. Windows will detect New Hardware, and prompt you to install driver. 2. Choose “Search for the best driver”. 3. Windows will find the necessary d

4. At the following prompt, click “Next”: 5. Click “Next”:

6. Assign a drive letter to the drive, then click “Next”: 7. Click on “Format this volume with the following settings:” Change the “File system” to

Figure B: 3. Locate the IDE power cable. Connect it to the IDE power port on your drive: Figure A:

8. Click “Finish”. Windows will now begin formatting and initializing the disk: 9. Open “My Computer” and verify that the drive shows up properly:

2. You may also need to change the HDD settings from Dynamic to Basic, then format NTFS, and give it a drive letter, but you should back up the data

To convert the disk to a GPT partition disk in Windows Vista and Windows 7: Open “Disk Management”, locate the disk in the list, right click the disk

Figure B: Figure C: 4. Locate the IDE data cable. Connect it to the IDE data port on your drive. Figure A:

Figure B: Figure C: 5. Insert the hard into the enclosure, as shown below: Figure A:

Figure B: 6. Place the cover back on the enclosure. Screw it back in place: Figure A:

3.5 Inch SATA Drive 1. Remove the screws, on the side without the fan, using the included screwdriver. Remove the panel: Figure A: Figure B:

1. Locate the SATA data port on the enclosure. Plug one end of the SATA data cable into the port. Figure A: Figure B:

Figure C: Figure D:

2. Locate the other end of the SATA power cable. Connect it to the SATA data port on your drive: Figure A: Figure B: Figure C: